Showing Visitor Messages 1 to 4 of 4
-
-
Oh, yeah! Mine is all chopped in the rear, so I only have one bolt in the center holding mine up. I think there were 3 originally. There are also two tabs on either side of the brake assembly- if you get your index finger and push it from the rear of the assembly toward you, one side at a time, it will pop right out. Get a flashlight and look over the whole thing before you start to dissamble.
-
Naw, it was not bad at all. I think it took me an hour to get the lens apart and the new one back in. Do you have a dremel? If not, go get one. I used a small cutting wheel cut (about an inch in diameter) the lens where it meets the grey plastic, all the way around. The instructions say to go about half-way thru the plastic, then use a screwdriver to pop it free. I just went all the way thru with the Dremel. Took out one screw for the old board, and pulled the old board out. Wire up the new one, by following the directions and provided wire clamps, and re-assamble. I used JB Weld and a few pairs of latex gloves to put it all back together. I think you will be fine. If you need anything else, let me know.
Joe
-
Hey where did you get the tail light conversion kit? I can't seem to find one anywhere. Thanks !
