|
|
| Cruisers Lots of chrome and an open road. Talk about it here! |
 |
| | LinkBack | Thread Tools |
09-25-2005, 04:18 AM
| #1 (permalink) |
| Newbie Join Date: Aug 2005
Posts: 8
|  Lower Kit
Hello all, I was going to replace my dogbones for the 3" drop kit from John's site. I am following Zukidude's instructions, which by the way are very good. I was going about it and noticed I might have to remove my exaust pipes to get a good angle on the nut side of the dogbone screws. Any advice on this? The bolt side is too tight and will strip if I use a breaker. Thank you all.
|
