Quote:
Originally Posted by rich/ginny  vinnie were did you get the strobe kit. always looking for a little more safety. |
I did not get it
HERE but this site is less than what I paid. I also bought the chrome bezel.
Just to let you know my procedure:
- Remove tail turn signal housing.
- Remove rear reflector, held by a nut from the inside of housing.
- Cut a 1/8"x1.5" alum bar down to fit snug into the reflector recess.
- Drill holes diagonally 3/4" around the center of the alum. bar for SS 8-32X1/2" phillips head machine screw.
- Countersink holes in alum bar and tap 8-32 holes in the housing.
- Install screws.
- Drill 1/2" hole, from the back side of housing, through the alum. bar & deburr or install a grommet.
- Mark holes for bezel mount on alum bar.
- Drill and tap marked holes for SS 8-32X3/4" SHCS. If the screws are a bit too long then grind them flush on the back side of alum. bar.
8-32X1/2" machine screw
8-32X3/4" SHCS
Hope this helps. It will be interesting to see if I get pulled over for this light. It has several program modes for strobe and one for solid.