Quote:
Originally Posted by RED-M  Georgia Roller, a word of advice... I have that same set up...when I used the supplied extension bolt it would not reach all the way through the large ISO pegs and 1 1/2" extenders (it touched but could not get the thread started)
I went to the local fastener supplier and had to get 2 that were about an inch longer...if they have stainless get them, I didn't and will need to replace them this spring because they rusted.  |
Well that's stupid!!! I'll see if they ship me the right length bolt or not. If I'm ordering the 1-1/2" extensions they should know what bolt to send. But that would require them to "think" which is probably asking to much I know.
Thanks for the heads up!