Motorcycle-Journal Forums - View Single Post

blackie1491 · 06-23-2006, 06:09 PM

Hi Tron;
I went out to-day to do. First I unpacked and took plate off mounted with the frame, note our plates are larger so the plate frane is a custom.
So it came with no instructions, no problem, I downloaded from Signal Dynamics and they stated there was enough wiring to go under the seat. Well of course there was not.
So I have it mounted but not wired. I live in a Condo, so the bike is undercover on the parking lot, which means I can not run back and forth leaving things laying around. I am going to check at where I can pickup at the rear tail light.
I prefer to not drill any holes in case I decide to reverse.
I will check on VolusiaRiders.com, I seem to recall seeing it.
I was hoping V0lsia would catch this and send me in the right direction, I have not seen him in awhile.
I should have drilled the plate, so the wires ran direct out the back, instead I ran them out the bolt holes, here we turn our plates in if we cancel insurance so I am not sure drilling them is legal.
I wanted the quad LED Frame but the dealer did not have a custom in stock and I refused to pay anymore. The dual was $140 Cdn.
I hope to have done on Monday as the wife is off for the next 2 days. I will post how I made out. Thanks for sharing.
Bob

06-23-2006, 06:09 PM	#3 (permalink)
blackie1491 I took the All Bran Challenge Joined: Jun 2005 Bike: C50SE Location: Aldergrove, B.C., Canada Posts: 7,211	Hi Tron; I went out to-day to do. First I unpacked and took plate off mounted with the frame, note our plates are larger so the plate frane is a custom. So it came with no instructions, no problem, I downloaded from Signal Dynamics and they stated there was enough wiring to go under the seat. Well of course there was not. So I have it mounted but not wired. I live in a Condo, so the bike is undercover on the parking lot, which means I can not run back and forth leaving things laying around. I am going to check at where I can pickup at the rear tail light. I prefer to not drill any holes in case I decide to reverse. I will check on VolusiaRiders.com, I seem to recall seeing it. I was hoping V0lsia would catch this and send me in the right direction, I have not seen him in awhile. I should have drilled the plate, so the wires ran direct out the back, instead I ran them out the bolt holes, here we turn our plates in if we cancel insurance so I am not sure drilling them is legal. I wanted the quad LED Frame but the dealer did not have a custom in stock and I refused to pay anymore. The dual was $140 Cdn. I hope to have done on Monday as the wife is off for the next 2 days. I will post how I made out. Thanks for sharing. Bob Last edited by blackie1491; 06-23-2006 at 06:12 PM.