[DrBob]

Remove the bolt from that black bar that braces the rear brake drum on the right side. Back off the adjuster nut from the end of the brake cable to free it from the lever, and pull out the brake cable from the little bracket on the drum. Jack the bike up. Remove the chrome axle cap from the right side of the swingarm using a knife or small screwdriver- be careful, it is plastic. Remove the axle nut under where the cap was. Use a drift or screwdriver to pull the axle out of the left side of the bike, putting the drift or screwdriver in the hole on the side of the axle as you work it side to side. There is a spacer on the axle between the wheel and the right side of the swing arm. If the spacer does not fall out, pull it out. Pull the wheel about an inch to the right side of the bike and it will disconnect from the shaft drive and come free.

When you put it back together put a drop of silicone on the axle cap to avoid loosing it.