Quote:
|
Originally Posted by Toolboy Billy,
On the fitting instructions #3 Troubleshooting its says "The TFI unit has a built in fault detection if you incorrectly hook up any other wires. It uses the green and or Red LED so that if the green light flashs after the bike is started the blue wire is on the wrong coloured wire at the tap connector. The red light flashing tells that the grey wire conection is incomplete"
I have both green and red lights flashing once the engine begins to idle???
Toolboy |
When you start it and it's going through the warm-up (high idle), on the TFI does only the green light come on then once it settles down to it's normal idle
all lights flash (yellow, green, and red) if so then that is normal. If not then call Dobeck and they can help you...also hold the throttle open till high idle, only the green will come on, now with the green on snap the throttle open smartly and then close just like you are blipping the throttle at a stop and you will see the yellow come on then go off. If it behaves just like I have described you have it fitted correctly...Zed